What is the difference between BSP and BSPT threads?

BSP (G thread, ISO 228) is parallel (straight) and uses a gasket or O-ring for sealing. BSPT (R thread, ISO 7) is tapered at 1:16 (55° Whitworth form) and seals by thread interference, often with PTFE tape.

What is the thread angle for BSP threads?

BSP threads use the Whitworth thread form with a 55° included angle, rounded crests and roots. This differs from NPT threads which use a 60° angle.

Are BSP and NPT threads interchangeable?

No, BSP and NPT are not compatible. BSP uses a 55° thread angle while NPT uses 60°. The OD values and TPI are different for most sizes. Adapters are required to connect between systems.

How do I identify BSP thread size?

Measure the OD of the male thread and count TPI (threads per inch). Then match to the BSP table. For example, ~20.9 mm OD with 14 TPI = G½. Note: BSP sizes refer to the bore of the pipe, not the thread OD.

What PTFE tape should I use on BSPT threads?

Use standard PTFE tape (0.1 mm thick, 12 mm wide) for water and air. For gas, use yellow gas-rated PTFE tape or liquid thread sealant. Apply 3–5 wraps in the tightening direction.

मोफत अभियांत्रिकी साधन — #150

पाईप थ्रेड रूपांतरक — BSP / BSPT

ISO 228 (G parallel) आणि ISO 7-1 (R taper) पाईप थ्रेड संदर्भ. OD, TPI, pitch, आणि tapping drill पाहण्यासाठी थ्रेड आकार निवडा.

ISO 228ISO 7-1BSP / BSPT55° Whitworth

थ्रेड माहिती

थ्रेड निर्दिष्टिकरण

—

मुख्य OD (mm)

—

TPI (Threads/inch)

—

पिच (mm)

—

टॅपिंग ड्रिल — समांतर (mm)

—

टॅपिंग ड्रिल — टेपर (mm)

—

आकार	OD (mm)	TPI	पिच (mm)	ड्रिल G (mm)	ड्रिल R (mm)

⚠️ Note: टॅपिंग ड्रिल आकार मार्गदर्शक म्हणून आहेत. प्रत्यक्ष pilot hole साहित्याप्रमाणे बदलू शकतो. taper threads साठी ड्रिल सरळ छिद्र तयार करतो; taper tap स्वतः कापतो.

BSP/BSPT Pipe Thread Converter — ISO 228 / ISO 7 Tool

Published by Nikolai Shelkovenko on फेब्रुवारी 15, 2026 एप्रिल 5, 2026

थ्रेड माहिती

Shop

आधार

Contact