Process of balancing the rotor: Mount the vibration sensors perpendicular to the rotor rotation axis. Mount the tachometer on the magnetic stand. Stick reflective tape on the pulley and point the RPM sensor toward the tape. Connect the sensors to the device and the device to the laptop. Start Read more…
This time we visit a home textile factory where down pillows and blankets are made. Before balancing, it is recommended to make measurements in vibrometer mode. If the value of the total vibration is approximately equal to the value of the reverse component, it can be assumed that the Read more…
In this video we will talk about combine harvesters. The process of balancing rotors on combine harvesters is no different from balancing any other rotors. For example fans, crushers, mulchers, augers, rotary machines, rotor motors, separators, couplings, spindles of CNC machines, hammer mills, centrifuges, flail mowers, sharpening stones. But Read more…
The rotor is a body which rotates about some axis and is held by its bearing surfaces in the supports. The bearing surfaces of the rotor transmit loads to the supports via rolling or sliding bearings. The bearing surfaces are the surfaces of the trunnions or the surfaces that replace Read more…
Earlier in the article, I described the modernization of an old balancing machine with soft-bearing supports. For such machines, we install the Balanset-1A balancing device in the case of machines with two supports, and the Balanset-4 in the case of machines with more supports. In this article, we will consider Read more…
Found an old correspondence between our lead specialist and one of our customers.Correspondence from ten years ago! Autor : Valery Davydovich Introduction I must admit that I was very surprised and pleased with the results of the letter written to us by Andrey Kobyakov, the driver of the motor grader. Read more…
In addition to using our equipment for balancing rotors in their own bearings, we have accumulated certain experience in its application as a measurement and computing block for resonant balancing machines, balancing machines for automobile crankshafts, balancing machines for cardan shafts, balancing machines for micro-electric motors’ rotors, balancing machines for Read more…
Balancing the rotors of electric motors after repair is a serious problem for many enterprises engaged in motor repair. Using balancing equipment allows solving this problem with minimal costs. For this purpose, we usually recommend that the customer make a simple stand, which is a welded frame installed on cylindrical Read more…
“Balanset-1” devices have been successfully used for hydraulic pumps rotor wheels balancing within their own bearings. This contributed to significant reduction of the dynamic loads affecting hydraulic pumps bearing units, which increased the service life and improved the operational reliability of the entire product.
For many companies engaged in electric motors repair, a serious problem is their rotors balancing after repair. The use of balancing equipment allows you to solve this problem with minimal cost. For this we usually recommend the Customer to manufacture a simple stand, which is a welded frame mounted on Read more…