হ্যামার কেন্দ্রীভূত বল ক্যালকুলেটর

Centrifugal force determines the load on hammer retention pins, bolts, and pivot points. It is essential for:

• Sizing fasteners (pins, bolts) for adequate shear and fatigue strength
• Designing rotor discs to withstand distributed loads
• Predicting hammer behavior (swing-out angle for swing hammers)
• Ensuring safe operation — a thrown hammer is a lethal projectile

A 5 kg hammer at 1500 RPM on R=400mm experiences ~49 kN — equivalent to hanging 5 tonnes from the pin.

Higher centrifugal force:

• Keeps swing hammers extended — hammers stay in radial position, maximizing effective diameter and impact energy
• Increases impact force — impact energy is proportional to mv² (tip speed squared)
• Higher pin loads — requires stronger retention hardware
• More disc stress — disc holes experience bearing stress from pins under centrifugal load

For a pin in double shear:

• Required pin area = F / (2 × τ_allow)
• Pin diameter = √(2F / (π × τ_allow))
• Use τ_allow = 60–80 MPa for medium carbon steel
• Apply safety factor 3–5 for dynamic/fatigue loads

Example: F = 49 kN, SF = 4, τ_allow = 70 MPa → d = √(2 × 49000 × 4 / (π × 70)) = 42 mm pin required.

Unequal hammer masses create unbalance forces that cause:

• Vibration — grows with RPM², leading to bearing failure
• Bearing damage — reduced bearing life by factor of (F/F₀)³
• Structural fatigue — cracking of frame, foundation bolts, and welds
• Poor product quality — uneven grinding, inconsistent particle size

Always weigh and arrange hammers for minimum unbalance.

Common causes of uneven wear:

• Non-uniform feed — material entering one side of the rotor more than the other
• Material variation — different hardness zones in feed material
• Screen condition — worn or damaged screen sections cause uneven discharge
• Breaker plate alignment — misaligned plates deflect material unevenly
• Initial mass differences — even small manufacturing tolerances compound over time

Implement a regular hammer rotation schedule: flip (180°), swap positions, and weigh before reinstalling.