六大主要分類
| 分類 | ISO 15243 代碼 | 子類型 |
| 1. 疲勞 | 5.1 | 次表面起始、表面起始 |
| 2. 磨損 | 5.2 | 磨粒磨損、黏著磨損(塗抹) |
| 3. 腐蝕 | 5.3 | 濕氣腐蝕、微動腐蝕 |
| 4. 電蝕 | 5.4 | 過大電流、電流洩漏(電蝕溝槽) |
| 5. 塑性變形 | 5.5 | 過載、凹痕(布氏壓痕) |
| 6. 裂紋與斷裂 | 5.6 | 強制斷裂、疲勞斷裂、熱裂紋 |
ISO 15243 將滾動軸承損壞分為六大類:疲勞、磨損、腐蝕、電蝕、塑性變形,以及破裂/斷裂。
疲勞剝落是預期的壽命終點失效。過早失效最常由污染、潤滑不足與安裝不當所造成。
疲勞的特徵是在受載區出現材料剝落(隨時間逐漸發展)。壓痕則表現為與滾動體間距相符的永久凹痕(單次過載事件所致)。
變頻器 (VFD) 驅動馬達產生的雜散電流會造成特有的搓板狀紋路。使用絕緣軸承或軸接地環即可預防。
妥善潤滑、污染控制、正確安裝、對中以及振動監測,是主要的預防措施。
本頁所述的操作流程由 Vibromera 團隊使用 Balanset-1A(一款用於現場轉子平衡的便攜式雙通道動平衡儀及振動分析儀)開發並經過實地測試。
Replace bearing. If premature: check load calculations, alignment, and lubrication adequacy.Improve lubrication (higher viscosity, cleaner oil). Check contamination sealing.Ensure minimum load. Improve lubrication. Check for proper preload.Improve sealing. Filter lubricant. Flush system before installation.Improve sealing. Use corrosion-resistant bearings (stainless steel). Proper storage.Improve fit (tighter interference). Use adhesive compounds. Reduce vibration during transport/standstill.Install insulated bearings (e.g., INSOCOAT). Use shaft grounding rings. Add common-mode filters.Avoid welding through bearings. Use insulated bearings. Ground the shaft properly.Check static safety factor s₀. Prevent shock loads. Use bearings with higher C₀ rating.Increase bearing size. Reduce applied loads. Check for misalignment.Check mounting practices. Verify fit tolerances. Inspect for proper support.Review lubrication type, quantity, and relubrication interval. Check for contamination.